Revolabs Solo Executive Operation Manual - Manual (Page 21)

- 18 -
In normal use, batteries should fully charge in about 2 hours, and can be
“quick-charged” to 80% capacity in 45 minutes.
The batteries of microphones left in the Charger Base remain solid GREEN.
Note: In earlier versions of microphone software the LED turns OFF when fully
charged, not GREEN. In all cases, a fully charged battery provides approximately
8 hours of talk time.
Pairing Wireless Microphones to Base Station
Pairing creates a link between the Solo wireless microphone and the Base
Station, with a unique electronic serial number. When the microphone and
Base Station have been previously paired, the mic will automatically try to
connect to the Base Station whenever it is lifted from the Charger Base.
Note: Note: Microphones in new systems must be paired to the Base Station
with each microphone assigned to a unique channel on the base unit.
Remember, microphones are always muted (flashing RED LED) when they are
removed from the Charger Base and the Mute button needs to be pressed to
make it “live” (flashing GREEN LED).
A microphone that is not paired will be indicated by either cycling RED-
GREEN, or RED-YELLOW-GREEN LED patterns. A Base Station channel that
is not paired to a microphone will not show any activity on the channel LED
(make sure unit is first powered on by observing GREEN power LED on the
front panel).
When channels are paired, both microphone and channel LEDs will flash RED
as microphones are removed from the Charger Base and flash GREEN when
un-muted. Remember that only one microphone can be paired to any single
Base Station channel.
To pair the microphone to the Base Station:
1. Turn the microphone OFF (no LED activity). If the microphone is ON, press
and hold the Mute button for 10 seconds until the LED turns solid RED (do
not release when you hear two beeps). Release the button to turn the unit
off.
2. Place the microphone unit into pairing mode by holding the Mute button
down for seven seconds. The LED will turn solid RED. Release the Mute
button. The microphone is now in pairing mode.
3. Within one minute, push and hold the button for the desired channel on the
Base Station for seven seconds to enter into pairing mode then release. The
LED for that channel will be solid red until pairing starts, as indicated by a