Revolabs Solo Executive Operation Manual - Manual (Page 20)

- 17 -
The Adapter does not provide phantom power or bias current so it cannot be
used with condenser or electret microphones.
2. With the microphone attached, un-mute the Adapter by pressing and
releasing the Mute button (confirm by viewing flashing GREEN LED).
Note: If the microphone has an on-board mute switch, this switch must
also be un-muted prior to use.
3. To turn the Adapter off, return the microphone unit to the Charger Base or
press and hold the Mute button for ~10 seconds until the LED turns solid
RED and release button.
Important: Always remove the microphone from the Adapter by pressing
the latch switch and separating the parts before returning the Adapter to
the Charger Base.
If the Adapter is moved too far from the Base Station (~100 feet or 30 meters)
the connection will be dropped (LED flashes all colors) and the audio will mute.
After 15 seconds the microphone will beep 5 times, and will continue beeping
every 30 seconds to indicate that it is out of range.
Move the XLR Adapter closer to the Base Station and the connection will
automatically be re-established to its original state, and the beeping will cease.
If not, the XLR Adapter will continue beeping until it turns off in about 15
minutes.
Charging the Microphone Batteries
First-time use — before using the wireless microphone the first time, charge
the batteries in the microphones for eight hours (or overnight) in the Charger
Base.
Recharging — when the YELLOW LED starts to flash intermittently on the
microphone the battery has 30 minutes of charge remaining. Over time (years),
batteries gradually wear down and require longer charging times. This is
normal. Always return microphones to the Charger Base when not in use.
Important: The Lithium Polymer rechargeable batteries that power the
microphones are not user serviceable. Please contact Revolabs
(www.revolabs.com) or your AV service provider for replacement instructions and
to assure the proper disposal method is used. Warning: Never dispose of
batteries in a fire because they may explode.
To charge the batteries place microphones into the Revolabs Solo™ Executive
Charger Base and the mic LED's will display a 5 blink "self test". During
charging, the LED indicator will be RED when mics are discharged and turn
GREEN when charged. The microphones are muted while in the Charger Base.