Revolabs Solo Executive Operation Manual - Manual (Page 9)

- 6 -
Using the Revolabs Solo™ Executive Charger Base
When Microphones are not in use, they should be properly inserted into the
Solo Executive Charger base. It is important to ensure that all system
microphones are inserted fully in the base so that charging will occur. Features
of the base are shown in the following figure.
1. System Mute Switch — overrides individual Microphone mute function.
2. LED indicator — power / mute status indicator.
3. Charger Bays — charges up to 8 Microphones.
4. Power Cord Receptacle — power supply input (on rear).
Power Module
The Charger Base requires 5VDC power, provided by the AC Adapter. Plug the
supplied AC adapter into an appropriate power outlet 110-240 AC, 50-60Hz.
The power LED on the Charger Base will illuminate.
System Mute Switch
The System Mute button (#1, in above figure) on the Charger Base mutes all
audio when pressed. During normal operation the Power Base LED will display
solid GREEN (power on). In this mode, mute individual microphones as needed.
Pressing the System Mute button will mute all wireless microphones in the
system and the Charger Base LED will turn RED. All active microphones will
display flashing RED LED status indicating that the microphone audio is
muted. To un-mute all microphones, press the system Mute button again. The
Charger Base LED will return to solid GREEN, and all microphones will return
to their state prior to the system mute.
Note: Pressing the Mute button on a microphone while the system mute is
active (solid RED LED on Charger Base) will NOT un-mute the microphone.