Revolabs Solo Executive Operation Manual - Manual (Page 18)

- 15 -
1. Mute button — press to mute, un-mute and pair microphone.
2. LED display — visual status for mute, un-mute, and pairing.
3. Integral grille — protects internal parts (non-removable).
4. Audio jack — accepts a 2.5mm plug.
5. Charging port — docks to Solo Charger Bases.
6. Rubber feet — non-slip, vibration absorbing pads.
To use the Revolabs Solo™ TableTop Microphone:
1. Remove the microphone from the Charger Base to turn on and
automatically mute the mic (indicated by a flashing RED LED) during
placement on the conference table.
2. TableTop microphones should be centered on the table with the integral grill
pointed toward the users (uni-directional), or centrally located between
users (omni-directional), from 2 to 5 feet (.75 to 1.75m) away. It is always
better to be as close to the person speaking as possible, but avoid placing
the microphone where it might be blocked by equipment or meeting
paperwork. Also do not place microphones too close to an audio or video
conference speaker to avoid echoes.
3. With the microphone in position, un-mute the microphone by pressing and
releasing the Mute button (confirm by viewing flashing GREEN LED).
4. To turn microphone off, return the microphone unit to the Charger Base or
press and hold the Mute button for ~10 seconds until the LED turns solid
RED and release button.
If the microphones are placed too far from the Base Station (~100 feet or 30
meters) the connection will be dropped (LED flashes all colors) and the
microphone will mute. After 15 seconds the microphone will beep 5 times, and
will continue beeping every 30 seconds to indicating it’s out of range.
Move the microphone closer to the Base Station and the connection will
automatically be re-established to its original state, and the beeping will cease.
If not, the microphone will continue beeping until it turns off in about 15
minutes.