Revolabs Solo Executive Operation Manual - Manual (Page 28)

- 25 -
Appendix B – Synchronized System Channel Settings
Note: Adjusting channel settings as described below should only be performed
by trained and authorized audiovisual personnel.
Revolabs Solo™ products contain MaxFlex™ technology, enabling multiple
systems within the same building. While adjusting power levels permits the use
of more Executive systems in a space, optimizing the RF channel selection of
multiple synchronized base stations avoids channel interference. Revolabs
Solo™ Base Stations are normally delivered from the factory configured for
unrestricted channel selection. This means that the Base Station selects the
best carrier frequencies to transmit and receive signals, avoiding interference
from other sources.
When a project needs more than 8 microphones and we synchronize it to
another Solo 4 or 8 channel system using the BUS connector, it is usually also
necessary to set the systems to alternate channel configurations to preclude
systems from interfering with each other. Interference between systems may
cause occasional audio noise and signal dropouts on affected systems. A
Revolabs Solo™ Executive system has two optional channel configurations
available when systems need to be synchronized: A Mode, and B Mode.
Remember that an 8-channel Executive base station rack unit has four radio
transceivers - each associated with a pair of audio channels - and that each
transceiver needs to be configured separately. Similarly, a 4-channel Executive
base station rack unit has two radio transceivers.
To configure the Revolabs Solo™ Executive 4 and 8 Channel base station
for synchronized channel modes:
1. Power-off base station at the power switch on the back of the unit.
2. Press and hold the CHANNEL 1 button, power-on the unit.