Lenovo ThinkServer RD440 User Manual
Page 129
9. Connect cables depending on your specific server configuration. See “Connecting the cables” on
10. Reinstall the riser card assembly 1. See “Replacing the riser card assembly 1” on page 176.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 199. Then, you might
need to configure RAID for your server. See “Configuring RAID” on page 74.
• After an expander card is installed, it might not be easy to check the current version of the expander
card firmware. It is recommended that you always go to and follow the
instructions on the Web page to download the latest version of firmware. Then, install the firmware to
your server.
Note: If you want to use the Firmware Updater program, ensure that it is the latest version. To get the
latest version of the Firmware Updater program, go to , locate different
versions of the program, and then identify the latest version by comparing readme files. If the latest
version of the Firmware Updater program does not contain the latest version of the driver you need,
download that driver separately from the Web page and install it individually to your server.
Removing the expander card
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 85.
This topic provides instructions on how to remove the expander card.
Attention:
• The server must have a RAID card and an expander card installed to support more than eight hard
disk drives.
• Ensure that you back up your data before removing the expander card because you might need to
reconfigure RAID and reinstall the operating system after removing the expander card.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• The card might look slightly different from the illustrations in this topic.
• Use any documentation that comes with the expander card and follow those instructions in addition to
the instructions in this topic.
To remove the expander card, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See “Removing the server cover” on page 87.
4. Remove the cooling shroud. See “Removing and reinstalling the cooling shroud” on page 95.
5. Remove the riser card assembly 1 and lay it upside down on a flat, clean, and static-protective surface.
See “Replacing the riser card assembly 1” on page 176.
Installing, removing, or replacing hardware
117