Lenovo ThinkServer RD440 User Manual
Page 33
Front view of server models with 2.5-inch hard-disk-drive bays
The following illustration shows the front view of server models with 2.5-inch hard-disk-drive bays.
Figure 9. Front view of server models with 2.5-inch hard-disk-drive bays
1
2.5-inch hard-disk-drive area (right cage)
5
Rack handle (left)
2
2.5-inch hard-disk-drive area (middle cage)
6
Diagnostic panel (varies by model)
3
Pull-out information card
7
Front panel
4
Slim optical drive (available in some models)
8
Rack handle (right)
1
2.5-inch hard-disk-drive area (right cage)
2
2.5-inch hard-disk-drive area (middle cage)
The front of server models with 2.5-inch hard-disk-drive bays consists of three cages:
• The left cage consists of the front panel board, the front VGA DB-15 connector, the diagnostic module,
the pull-out information card, and the slim optical drive bay.
• The middle cage consists of the number 0 to number 7 hard-disk-drive bays. There is either a 2.5-inch
hot-swap hard disk drive or a 2.5-inch dummy hard-disk-drive tray installed in each bay.
• The right cage consists of the number 8 to number 15 hard-disk-drive bays. There is either a 2.5-inch
hot-swap hard disk drive or a 2.5-inch dummy hard-disk-drive tray installed in each bay. If the server
supports up to eight hard disk drives, there will be an EMI-protective panel that covers the right cage
as a whole.
Figure 10. Right cage with an EMI-protective panel
Note: The hard-disk-drive bay number (0-15) is marked above each 2.5-inch hard-disk-drive bay on the
front bezel.
3
Pull-out information card
The machine type, model, and serial number label of the server is attached on the pull-out information card.
See “Machine type, model, and serial number label” on page 14.
21