Lenovo ThinkServer TS440 - Manual (Page 129)

6. Remove the two screws that secure the solid-state drive.
Figure 73. Removing the screws that secure the solid-state drive
7. Lift the solid-state drive up to remove it from the drive adapter.
Figure 74. Removing the solid-state drive from the drive adapter
8. Install a new solid-state drive. See “Installing a 2.5-inch solid-state drive into a 3.5-inch hard-disk-drive
bay” on page 108.
9. If you are instructed to return the old solid-state drive, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To configure RAID, go to “Configuring RAID” on page 57.
• To complete the replacement, go to “Completing the parts replacement” on page 157.
Installing or replacing a hot-swap hard disk drive
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 65.
Chapter 6 . Installing, removing, or replacing hardware 117