Lenovo ThinkServer TS440 - Manual (Page 146)

9. Do one of the following:
• For the backplane for server models with 3.5-inch hard-disk-drive bays, remove the four screws that
secure the backplane, and then remove the backplane from the hard-disk-drive cage.
Figure 87. Removing the backplane for server models with 3.5-inch hard-disk-drive bays
• For the backplane for server models with 2.5-inch hard-disk-drive bays, remove the six screws or
three screws that secure the backplane depending on the type of the backplane. Then, remove
the backplane from the hard-disk-drive cage.
Figure 88. Removing the backplane for server models with 2.5-inch hard-disk-drive bays
10. Touch the static-protective package that contains the new hot-swap hard-disk-drive backplane to any
unpainted surface on the outside of the server. Then, remove the new backplane from the package.
Note: Carefully handle the backplane by its edges.
11. Position the new backplane on the hard-disk-drive cage so that the screw holes in the new backplane
are aligned with the corresponding holes in the hard-disk-drive cage. Then, do one of the following
depending on the hard-disk-drive cage:
134 ThinkServer TS440 User Guide