Lenovo ThinkServer TS440 - Manual (Page 22)

– Ability to store the power-on self-test (POST) hardware test results
– BIOS Setup Utility program
The BIOS Setup Utility program helps you view the server information and configure the server in the
pre-operating system environment. See “Using the Setup Utility program” on page 47.
– Hot-swap feature
Some models support hot-swap hard disk drives and hot-swap redundant power supplies. With
the hot-swap feature, you can install, remove, or replace hard disk drives or a failing power supply
without turning off the server.
– Preboot Execution Environment (PXE)
The Intel PXE technology enables you to start your computers, load an operating system, or deploy
executable images from a remote server by using a network interface. The operation can be done
independently of local data storage devices (such as hard disk drives) or installed operating systems.
– Redundant Array of Independent Disks (RAID)
Your server supports onboard SATA software RAID. If a required RAID card is installed, your server
also supports advanced SATA/SAS hardware RAID configurations. For detailed information, see
“Configuring RAID” on page 57.
– Status light-emitting diodes (LEDs) and diagnostic LEDs
For more information about the LEDs for your server, refer to the related topics in “Locations” on
page 12.
– Software programs
For more information about the software programs, see “Software” on page 11.
10 ThinkServer TS440 User Guide