Lenovo ThinkServer TS440 User Manual
Page 137
Advertising
2. If you are replacing a hot-swap redundant power supply, press the release tab
1
in the direction as
shown and carefully pull the handle
2
at the same time to slide the failing hot-swap redundant power
supply out of the chassis.
Note: Do not use too much strength. You can first carefully slide the redundant power supply a little bit
out to release it from the secured position. Then, completely slide it out of the chassis.
Figure 80. Removing a hot-swap redundant power supply
3. Touch the static-protective package that contains the new hot-swap redundant power supply to any
unpainted surface on the outside of the server. Then, remove the new hot-swap redundant power
supply from the package.
Installing, removing, or replacing hardware
125
Advertising