Lenovo S310 All-in-One - Manual (Page 63)

Diagnostic Error Code FRU/Action
000-198-XXX BIOS test aborted 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.
2. Flash the system and retest. See “Flash update
procedures” on page 127.
3. Go to “Undetermined problems” on page 76.
000-199-XXX BIOS test failed, cause unknown 1. Go to “Undetermined problems” on page 76.
2. Flash the system and re-test.
3. Replace component under function test.
000-250-XXX BIOS APM failure 1. Flash the system. See “Flash update procedures”
on page 127.
2. System board
000-270-XXX BIOS ACPI failure 1. Flash the system. See “Flash update procedures”
on page 127.
2. System board
001-000-XXX System Test Passed No action
001-00X-XXX System Error System board
001-01X-XXX System Error System board
001-024-XXX System Addressing test failure System board
001-025-XXX System Checksum Value error 1. Flash the system. See “Flash update procedures”
on page 127.
2. System board
001-026-XXX System FLASH data error 1. Flash the system. See “Flash update procedures”
on page 127.
2. System board
001-027-XXX System Configuration/Setup error 1. Run the Setup Utility program.
2. Flash the system. See “Flash update procedures”
on page 127.
3. System board
001-032-XXX System Device Controller failure System board
001-034-XXX System Device Buffer Allocation failure 1. Reboot the system.
2. Flash the system. See “Flash update procedures”
on page 127.
3. Run memory test.
4. System board
001-035-XXX System Device Reset condition detected System board
001-036-XXX System Register error System board
001-038-XXX System Extension failure 1. Adapter card
2. System board
001-039-XXX System DMI data structure error 1. Flash the system. See “Flash update procedures”
on page 127.
2. System board
001-040-XXX System IRQ failure 1. Power-off/on system and re-test.
2. System board
Chapter 7 . Symptom-to-FRU Index 57