Lenovo S310 All-in-One User Manual
Page 77
Diagnostic Error Code
FRU/Action
175-195-XXX Thermal Sensor(s) Test aborted by user
Information only Restart the test, if necessary.
175-196-XXX Thermal Sensor(s) test halt, error threshold
exceeded
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
175-197-XXX Thermal Sensor(s) test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
175-198-XXX Thermal Sensor(s) test aborted
1. If a component is called out, make sure it is
connected and/or enabled .
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 76.
175-199-XXX Thermal Sensor(s) test failed, cause
unknown
1. See “Undetermined problems” on page 76.
2. Flash the system and re-test. See “Flash update
3. Replace component under function test.
175-250-XXX 175-251-XXX Thermal Sensor(s) limit error
1. Check fans
2. Check power supply voltages.
3. Microprocessor
4. System board
185-000-XXX Asset Security Test Passed
No action
185-XXX-XXX Asset Security failure
1. Flash system
2. System board
185-278-XXX Asset Security Chassis Intrusion
1. Assure Asset Security Enabled
2. C2 Cover Switch
3. System board
201-000-XXX System Memory Test Passed
No action
201-XXX-XXX System Memory error
1. Replace the memory module called out by the test.
2. System board
202-000-XXX System Cache Test Passed
No action
202-XXX-XXX System Cache error
1. Cache, if removable
2. System board
3. Microprocessor
206-000-XXX Diskette Drive Test Passed
No action
206-XXX-XXX Diskette Drive error
1. Diskette Drive Cable
2. Check power supply voltages
3. Diskette drive
4. System board
215-000-XXX CD-ROM Drive Test Passed
No action
Chapter 7
.
Symptom-to-FRU Index
71