Lenovo S310 All-in-One User Manual

Page 68

Advertising
background image

Diagnostic Error Code

FRU/Action

011-198-XXX Serial port test aborted

1. If a component is called out, make sure it is

connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.

2. Flash the system and re-test. See “Flash update

procedures” on page 127.

3. Go to “Undetermined problems” on page 76.

011-199-XXX Serial port test failed, cause unknown

1. Go to “Undetermined problems” on page 76.

2. Flash the system and re-test. See “Flash update

procedures” on page 127.

3. Replace component under function test.

011-2XX-XXX Serial port signal failure

1. External serial device

2. System board

014-000-XXX Parallel port Interface Test Passed

No action

014-001-XXX Parallel port Presence

1. Remove external parallel device, if present.

2. Run the Setup Utility program, enable port

3. System board

014-002-XXX 014-003-XXX Parallel port Timeout/Parity
error

System board

014-013-XXX 014-014-XXX Parallel port Control
Signal/Loopback test failure

System board

014-015-XXX Parallel port External Loopback failure

1. Wrap plug

2. System board

014-027-XXX Parallel port Configuration/Setup error

1. Run the Setup Utility program, enable port

2. Flash the system. See “Flash update procedures”

on page 127.

3. System board

014-03X-XXX 014-04X-XXX Parallel port failure

System board

014-195-XXX Parallel port Test aborted by user

Information only Restart the test, if necessary.

014-196-XXX Parallel port test halt, error threshold
exceeded

1. Press F3 to review the log file.

2. Restart the test to reset the log file.

014-197-XXX Parallel port test warning

1. Make sure the component that is called out is

connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.

2. Re-run test.

3. Replace the component that is called out in warning

statement.

4. Replace the component under test.

014-198-XXX Parallel port test aborted

1. If a component is called out, make sure it is

connected and/or enabled.

2. Flash the system and re-test. See “Flash update

procedures” on page 127.

3. Go to “Undetermined problems” on page 76.

62

Lenovo S310 All-In-OneHardware Maintenance Manual

Advertising