Lenovo S310 All-in-One User Manual
Page 67
Diagnostic Error Code
FRU/Action
006-196-XXX Diskette interface test halt, error threshold
exceeded
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
006-197-XXX Diskette interface test warning
1. If a component is called out, make sure it is
connected and/or enabled.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
006-198-XXX Diskette interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled.
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 76.
006-199-XXX Diskette interface test failed, cause unknown
1. Go to “Undetermined problems” on page 76.
2. Flash the system and re-test.
3. Replace component under function test.
006-25X-XXX Diskette interface Error
1. Diskette drive cable
2. Diskette drive
3. System board
011-000-XXX Serial port Interface Test Passed
No action
011-001-XXX Serial port Presence
1. Remove external serial device, if present.
2. Run the Setup Utility program, enable port.
3. System board
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error
System board
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure
System board
011-015-XXX Serial port External Loopback failure
1. Wrap plug
2. System board
011-027-XXX Serial port Configuration/Setup error
1. run the Setup Utility program, enable port
2. Flash the system. See “Flash update procedures”
3. System board
011-03X-XXX 011-04X-XXX Serial port failure
System board
011-195-XXX Serial port Test aborted by user
Information only Restart the test, if necessary.
011-196-XXX Serial port test halt, error threshold exceeded
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
011-197-XXX Serial port test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.
2. Re-run test
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
Chapter 7
.
Symptom-to-FRU Index
61