Tcp/ip administration, Operations – American Power Conversion AmpMeter PDU User Manual

Page 28

Advertising
background image

3. Operations

Creating a descriptive infeed name

The Set Infeed Name command assigns a descriptive name to an infeed. This descriptive name is displayed
when the Show Traps command is issued.

To create a infeed name:

At the AmpMeter PDU: prompt, type

set infeed name

, followed by the absolute infeed name, then the

descriptive name of up to 24 alphanumeric and other typeable characters (ASCII 33 to 126 decimal - spaces
are not allowed). Press

Enter

.

Example

The following command adds the descriptive name HQ_1_Infeed_A to the infeed on the AmpMeter PDU:

AmpMeter PDU: set infeed name .aa HQ_1_Infeed_A<Enter>

Displaying Infeed information

The Show Infeeds command displays information about all infeeds. This information includes the absolute and
descriptive infeed names.

To display tower information:

At the AmpMeter PDU: prompt, type

show infeeds

and press

Enter

.

Example

AmpMeter PDU: show infeeds<Enter>
Input Input
Feed ID Feed Name
.AA HQ_1_Infeed_A
.AB HQ_1_Infeed_B
.BA HQ_2_Infeed_A
.BB HQ_2_Infeed_B

Displaying the firmware version

The Version command displays the firmware version.

To display the firmware version:

At the AmpMeter PDU: prompt, type

version

and press

Enter

.

Performing a warm boot

The Restart command performs a warm boot of the AmpMeter PDU.

NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this
command.

To perform a warm boot:

At the AmpMeter PDU: prompt, type

restart

and press

Enter

.

TCP/IP Administration

NOTE: A restart of the AmpMeter PDU is required after setting or changing ANY TCP/IP configurations. See
Performing a warm boot on page 28 for more information.

Setting the IP address

The Set Ipaddress command sets the TCP/IP address of the network interface controller.

To set the IP address:

At the AmpMeter PDU: prompt, type

set ipaddress

, followed by the IP address and press

Enter

.

Example

The following command sets the IP address to 12.34.56.78:

AmpMeter PDU: set ipaddress 12.34.56.78<Enter>

Page 28 - 301-0399-3 Rev A.

Advertising