AMX Signature Series NetLinx Integrated Controller NI-3101-SIG - Manual (Page 106)

NetLinx Security within the Web Server
96 NI-3101-SIG Signature Series NetLinx Integrated Controller
9. Click Yes from the Security Alert popup window to agree to the installation of the G4 WebControl
application on your computer. This application contains the necessary Active X and VNC client
applications necessary to properly view and control the panel pages from your computer.
10. Some circumstances might open a Connection Details dialog (FIG. 78) requesting a VNC Server IP
Address. This is not the IP of the Master but of the target touch panel. Depending on which method of
communication you are using, it can be found in either the:
 Wired Ethernet - System Connection > IP Settings section within the IP Address field.
 Wireless - Secondary Connection > IP Settings section within the IP Address field.
If this field does not appear, continue to step 11.
11. If a WebControl password was setup on the G4 WebControl page, a G4 Authentication Session password
dialog box appears on the screen within the secondary browser window.
12. Enter the WebControl session password into the Session Password field (FIG. 77). This password was
previously entered into the Web Control Password field within the G4 Web Control page on the panel.
13. Click OK to send the password to the panel and begin the session. A confirmation message appears
stating "Please wait, Initial screen loading..".
The secondary window then becomes populated with the same G4 page being displayed on the target G4
panel. A small circle appears within the on-screen G4 panel page and corresponds to the location of the mouse
cursor. A left-mouse click on the computer-displayed panel page equates to an actual touch on the target G4
panel page.
FIG. 77 WebControl VNC installation and Password entry screens
The G4 WebControl application is sent by the panel to the computer that is used for
communication. Once the application is installed, this popup no longer appears. This
popup only appears if connecting to the target panel using a different computer.
FIG. 78 Connection Details dialog
IP Address of touch panel
- obtained from IP Settings section of
the panel’s System Connection page