AMX Signature Series NetLinx Integrated Controller NI-3101-SIG - Manual (Page 133)

Programming
123 NI-3101-SIG Signature Series NetLinx Integrated Controller
Configuration Port Commands (Cont.)
Command Description
SET DNS <D:P:S>
Prompts you to enter a Domain Name, DNS IP #1, DNS IP #2, and DNS
IP #3. Then, enter Y (yes) to approve/store the information in the Master.
Entering N (no) cancels the operation.
Example:
> SET DNS [0:1:0]
-- Enter New Values or just hit Enter to keep current
settings --
Enter Domain Suffix: amx.com
Enter DNS Entry 1 : 192.168.20.5
Enter DNS Entry 2 : 12.18.110.8
Enter DNS Entry 3 : 12.18.110.7
You have entered: Domain Name: amx.com
DNS Entry 1: 192.168.20.5
DNS Entry 2: 12.18.110.8
DNS Entry 3: 12.18.110.7
Is this correct? Type Y or N and Enter -> Y
Settings written. Device must be rebooted to enable new
settings
SET DUET MEMORY
Set the amount of memory allocated for Duet Java pool. This is the cur-
rent Java memory heap size as measured in Megabytes. This
feature is used so that if a NetLinx program requires a certain size of
memory be allotted for its currently used Duet Modules, it can be reserved
on the target Master.
Valid values are 1 - 16 for 32 MB systems and 1 - 48 for a 64 MB
system. This setting does not take effect until the next reboot.
Note: If you are trying to accomplish this setting of the Duet Memory size
via a NetLinx program, the program command
"DUET_MEM_SIZE_SET(int)" should call REBOOT() following a set.
SET ETHERNET MODE <CMD> This command sets the current LAN configuration settings -
auto OR speed = 10 | 100, duplex = full | half
Example:
set ethernet mode auto
set ethernet mode speed=100 duplex=full
Note: See GET ETHERNET MODE.
SET FTP PORT Enables/Disables the IP port listened to for FTP connections.
Example:
>SET FTP PORT
FTP is enabled
Do you want to enable (e) or disable (d) FTP (enter e or d)
:
FTP enabled, reboot the master for the change to take
affect.
SET HTTP PORT Sets the IP port listened to for HTTP connections.
Example:
>SET HTTP PORT
Current HTTP port number = 80
Enter new HTTP port number (Usually 80) (0=disable HTTP) :
Setting HTTP port number to
New HTTP port number set, reboot the master for the change
to take effect.