AMX Signature Series NetLinx Integrated Controller NI-3101-SIG - Manual (Page 130)

Programming
120 NI-3101-SIG Signature Series NetLinx Integrated Controller
Configuration Port Commands (Cont.)
Command Description
GET ETHERNET MODE
Displays the current LAN configuration setting.
Settings are either "auto" in which the LAN driver will discover it's settings
based on the LAN it is connected to OR <speed> and <duplex> where
speed is either 10 or 100 and duplex is either full or half.
Example:
get ethernet mode
Ethernet mode is auto.
Note: See SET ETHERNET MODE.
GET IP <D:P:S>
Displays the Master's D:P:S, Host Name, Type (DHCP or Static), IP
Address, Subnet Mask, Gateway IP, and MAC Address.
Example:
>GET IP [0:1:50]
IP Settings for 0:1:50
HostName MLK_INSTRUCTOR
Type DHCP
IP Address 192.168.21.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.21.2
MAC Address 00:60:9f:90:0d:39
HELP SECURITY Displays the related security commands:
Example:
>HELP SECURITY
>logout Logout and close secure session
>setup security Access the security setup menus
ICSPMON ENABLED|DISABLED
[PORT] Enables or disables ICSP monitoring out the specified IP port.
By enabling icspmon on an IP port, an external application could connect
to that port and "listen" on the ICSP traffic.
IP STATUS Provides information about the current NetLinx IP Connections:
Example:
>IP STATUS
NetLinx IP Connections
No active IP connections
MEM
Displays the largest free block of the Master’s memory.
Example:
>MEM
The largest free block of memory is 11442776 bytes.
MSG ON or MSG OFF MSG On sets the terminal program to display all messages generated by
the Master. MSG OFF disables the display.
Example:
> MSG ON
Extended diagnostic information messages turned on.
> MSG OFF
Extended diagnostic information messages turned off.
OFF <D:P:S, or NAME, CHAN>
Turns off a channel on a device. The device can be on any system the
Master you are connected to can reach. You can specify the device
number, port, and system, or the name of the device that is defined in the
DEFINE_DEVICE section of the program.
Syntax:
OFF[name,channel]
-or-
OFF[D:P:S,channel]
Example:
>OFF[5001:7:4]
Sending Off[5001:7:4]