AMX Signature Series NetLinx Integrated Controller NI-3101-SIG - Manual (Page 14)

Introduction
4 NI-3101-SIG Signature Series NetLinx Integrated Controller
NI-3101-SIG Specifications (Cont.)
IR/Serial (Ports 9 - 16) Eight IR/Serial control ports support high-frequency carriers up to
1.142 MHz.
• Each output is capable of three electrical formats: IR, Serial, and Data
• Eight IR/Serial data signals can be generated simultaneously.
• Channel range = 1-32,767
• Channels 1-128 (output): IR commands
• Channels 129-253: used as reference channels
• Channel 254 (feedback): Power Fail (used with 'PON' and 'POF'
commands)
• Channel 255 (feedback): Power status (when IO Link is set)
• IR ports support data mode (at limited baud rates and wiring distances).
• Two 8-pin 3.5 mm mini-Phoenix (female) connectors provide IR/Serial port
termination
Configuration Port USB connector (male) can be connected to a USB port on a computer. This
low-speed USB connection is used to configure system settings.
Not recommended for firmware updates or large file transfers.
Configuration DIP switch 4 configuration DIP switches used solely for enabling or disabling NetLinx
functionality.
ID pushbutton Provides the NetLinx ID (Device only) assignment for the device. Refer to
the Changing the Device Address of a NetLinx Device section on page 20.
• The D notation is used to represent a device number.
LAN port RJ-45 port for 10/100 Mbps communication.
This port automatically negotiates the connection speed (10 Mbps or 100
Mbps) and whether to use half duplex or full duplex mode.
LAN Link/Activity LED LEDs show communication activity, connection status, speeds, and mode
information:
• SPD (speed) - Yellow LED lights On when the connection speed is 100
Mbps and turns Off when the speed is 10 Mbps.
• L/A (link/activity) - Green LED lights On when the LAN cables are
connected/terminated correctly, and blinks when receiving LAN data
packets.
AXlink LED • Green LED indicates the state of the AXlink connector port.
• Normal AXlink activity = 1 blink/second
• Abnormal AXlink activity = cycle of 3 consecutive blinks and then Off
AXlink port 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to
external control devices.
Power port 2-pin 3.5 mm mini-Phoenix (male) connector
Included Accessories: • 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
• 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
• 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)
• Installation Kit (KA2105-02):
Two rack mount ears
Four #8-32 Phillips flat head screws
• NI-3101-SIG Quick Start Guide (93-2105-08)
• Two 8-pin 3.5 mm mini-Phoenix (female) Relay connectors (41-5083)
• Two CC-NIRC IR Emitters
Other AMX Equipment: • 2-pin 3.5 mm mini-Phoenix male connector (41-5026)
• CC-NIRC IR cables (FG10-000-11)
• CC-NSER IR/Serial cables (FG10-007-10)
• CSB Cable Support Bracket (FG517)
• NCK, NetLinx Connector Kit (FG2902)
• USB A to B cable (FG10-2105)