Olympus LS-10S - Manual (Page 13)

13
Ge
tti
ng S
ta
rte
d
1
Power Supply
Turning On the Power:
While the recorder’s power is off, slide
the POWER/HOLD switch in the direction
indicated by the arrow.
• The display will turn on, and the power will be
turned on.
• The resume function will bring the recorder
back to the stop position in memory before
power was turned off.
• When the batteries are removed from the
recorder the resume function’s stopped position
will be erased.
Power save mode [AutoPowerOff]
If the recorder is stopped/not used for over 10
minutes (initial setting) while the power is turned
on, the power will be turned off ( ☞ P.41, P.47).
• If any button is pressed prior to the battery
turning off, the elapsed time count will start
over again until this function takes effect.
HOLD
Set the recorder to HOLD mode
Slide the POWER/HOLD switch to the [HOLD]
position.
• After [Hold] appears on the display, the
recorder is set to HOLD mode.
When the recorder is not being used, turn the
power off to reduce battery consumption to a
minimum. Even if the power is turned off, existing
data, mode settings, and clock settings will be
maintained.
If you bring the recorder is set to HOLD mode,
the current conditions will be preserved, and all
buttons will be disabled. This feature is useful
when the recorder has to be carried in a bag or
pocket.
Exit HOLD mode
Slide the POWER/HOLD switch to the A
position.
Turning Off the Power:
Slide the POWER/HOLD
switch in the direc-
tion indicated by the arrow for 1 second
or longer.
• The display shuts off and the power will be
turned off.
• The resume function remembers the stop
position before the power is turned off.