Olympus LS-10S - Manual (Page 31)

31
Ab
ou
t R
ec
or
din
g
2
To LINE IN
jack
To audio output
terminal of other
devices
To EAR
jack
To audio input
terminal of
other devices
Notes
• If you are unable to produce a clear recording
with this recorder even after adjusting the
recording level ( ☞ P.23), this could potentially
be because the output level for the connected
devices is too high or too low. When external
devices are connected, perform a test record-
ing and then adjust the output level for the
external devices.
• Do not connect the connecting cord to the MIC
jack when recording sound from other device
with this recorder.
Recording the Sound of Other Devices with
This Recorder:
The sound can be recorded when connecting to
the audio output terminal (earphone jack) of the
other device, and the LINE IN jack of the recorder
with the connecting cord KA334 (optional) for
dubbing.
Notes
• When you adjust the various sound quality
settings related to playback on the recorder,
the audio output signal sent out from the EAR
jack will change as well ( ☞ P.41, P.45).
• In case of recording on other devices without
a line input, the input may be too large to con-
trol when the audio is input to the microphone
jack. In this case, use the connecting cord
KA333 (optional) with attenuation resistance
( ☞ P.82).
Recording the Sound of This Recorder with
Other Devices:
The sound of this recorder can be recorded to
other devices when connected to the audio input
terminal (line jack) of other devices and the EAR
jack of this recorder, with the connecting cord
KA334 (optional) for dubbing.
Recording