Olympus LS-10S - Manual (Page 83)

83
Other Information
6
Specifications
General points
4 Recording format:
Linear PCM (Pulse Code Modulation)
MP3 (MPEG-1/MPEG-2 Audio Layer3)
WMA (Windows Media Audio)
4 Input level:
MIC SENSE HIGH/LOW switch is set to [HIGH]:
- 59 dBv
MIC SENSE HIGH/LOW switch is set to [LOW]:
- 39 dBv
LINE IN jack input:
- 6 dBv
4 Maximum headphone output:
6.7 mW + 6.7 mW (at load of 16 Ω)
≤
_ 150 mV (According to EN 50332-2)
4 Recording medium:
Built-in NAND FLASH memory (2 GB)
SD card (512 MB to 32 GB)
4 Speaker:
Built-in ø 16 mm round dynamic speaker
4 MIC jack:
ø 3.5 mm mini-jack, impedance 2 kΩ
4 LINE IN jack:
ø 3.5 mm mini-jack, impedance 78 kΩ
(approx.)
4 EAR jack:
ø 3.5 mm mini-jack, impedance 8 Ω or more
4 Maximum working output:
200 mW + 200 mW (8 Ω speaker)
4 Input power requirement:
Batteries: Two AA batteries (LR6) or Two
Ni-MH rechargeable batteries
External power supply: AC adapter 5 V
4 External dimensions:
131.5 mm × 48 mm × 22.4 mm
(without protrusions)
4 Weight:
165 g (including alkaline batteries)
4 LINE IN Jack (During recording or playback
mode):
Linear PCM format
Recording mode Overall frequency response
96 kHz 20 Hz to 44 kHz
88.2 kHz 20 Hz to 42 kHz
48 kHz 20 Hz to 23 kHz
44.1 kHz 20 Hz to 21 kHz
44.1 kHz/mono 20 Hz to 21 kHz
MP3 format
Recording mode Overall frequency response
320 kbps 50 Hz to 20 kHz
256 kbps 50 Hz to 20 kHz
128 kbps 50 Hz to 17 kHz
mono 50 Hz to 13 kHz
WMA format
Recording mode Overall frequency response
160 kbps 50 Hz to 19 kHz
128 kbps 50 Hz to 19 kHz
64 kbps 50 Hz to 15 kHz
mono 50 Hz to 13 kHz
4 Built-in stereo microphone (During
recording mode):
60 Hz to 20 kHz
• However, when recording by the MP3
format or the WMA format, the upper
limit value of the frequency response
depends on each recording mode (see
above diagram).
Overall frequency response