Pioneer VSX-828-K - Manual (Page 35)

Basic playback 4 4
35
65
7
4  Manual tuning
To change the frequency one step at a time, press
TUNE / .
 High speed tuning
Press and hold
TUNE / for high speed tuning.
Improving FM sound
If the TUNE or ST indicators don’t light when tuning to an FM
station because the signal is weak, set the receiver to the
mono reception mode.

Press BAND to select FM MONO.
This should improve the sound quality and allow you to
enjoy the broadcast.
Saving station presets
If you often listen to a particular radio station, it’s convenient
to have the receiver store the frequency for easy recall
whenever you want to listen to that station. This saves the
effort of manually tuning in each time. This unit can memorize
up to 30 stations.
1 Tune to a station you want to memorize.
See
Listening to the radio above for more on this.
2 Press TOOLS .
The display shows PRESET, then a blinking MEM and
station preset.
3 Press PRESET / to select the station preset you
want.
You can also use the number buttons.
4 Press ENTER .
The preset number stop blinking and the receiver stores
the station.
Note
• If the receiver is left disconnected from the AC power outlet
for over a month, the station memories will be lost and will
have to be reprogrammed.
• Stations are stored in stereo. When the station is stored in
the FM MONO mode, it shows as ST when recalled.
Listening to station presets
You will need to have some presets stored to do this. See
Saving station presets above if you haven’t done this already.

Press PRESET / to select the station preset you
want.
• You can also use the number buttons on the remote
control to recall the station preset.
Naming preset stations
For easier identification, you can name all of your preset
stations.
1 Choose the station preset you want to name.
See
Listening to station presets above for how to do this.
2 Press TOOLS twice.
The cursor at the first character position is blinking on
the display.
3 Input the name you want.
Choose a name up to eight characters long.
• Use PRESET / to select character position.
• Use TUNE / to select characters.
• The name is stored when ENTER is pressed.
Tip
• To erase a station name, follow steps 1 and 2, and press
ENTER while the display is blank. Press TOOLS while the
display is blank, to keep the previous name.
• Once you have named a station preset, Press DISP to show
the name. When you want to return to the frequency
display, press DISP several times to show the frequency.
Changing the radio frequency step (for Australia)
If you find that you can’t tune into stations successfully, the
frequency step may not be suitable for your country/region.
Here’s how to switch the setting:
1 Switch the receiver into standby.
2 While holding down TUNE  button, press and hold
STANDBY/ON button for about two seconds.
The channel tuning step alternates between 10K STEP
and 9K STEP each time you do this.
SLEEP
INPUT
RECEIVER
RECEIVER
SOURCE
1
ENTER
2 DISP 3
MUTE
RETURN
AUDIO PARAMETER MENU
HOME
MENU
TOOLS
BAND iPod CTRL PTY
TOP MENU
TUNE
TUNE
P R E S E T P R E S E T
ENTER
DISP
VSX-828_SYXE8_En.book 35 ページ ２０１３年３月１日 金曜日 午前９時１６分