Pioneer VSX-AX3-S - Manual (Page 33)

Displays and Controls
33
En
PREPARATION
Display
All the display information is explained and/or referenced here.
1 SIGNAL indicators
Light to indicate the input signal you selected.
AUTO: Lights when the receiver is set to select
the input signal automatically.
DIGITAL: Lights when digital audio signals are
selected.
ANALOG: Lights when analog signals are
selected.
2 Digital format indicators
PRO LOGIC II: Lights during Dolby Pro Logic II
processing.
NEO:6: Lights during NEO:6 processing.
2 DIGITAL: Lights when a Dolby Digital signal
is detected.
DTS: Lights when a DTS signal is detected.
ES: Lights when playing back a DTS ES signal.
EX: Lights when playing back a Dolby Digital EX
signal.
STEREO: Lights during two-channel playback.
3 LOUDNESS indicator
Lights when LOUDNESS is on.
4 MIDNIGHT indicator
Lights when MIDNIGHT is on.
5 TONE indicator
Lights when the TONE control is on.
6 DNR indicator
Lights when DIGITAL NR is on.
7 TUNER indicators
STEREO: Lights when an FM stereo broadcast is
received in the auto stereo mode.
MONO: Lights when the tuner is set to receive
FM broadcasts and when MPX mode is selected.
TUNED: Lights when a broadcast is received.
RF ATT (European model only): Lights when the
RF ATT is on (see page 56).
RDS (European model only): Lights when an RDS
broadcast is received.
EON (European model only): EON lights when
it has been set. The dot indicator next to it lights
when the station you are currently tuned to
carries the EON data service.
8 Volume level indicator
9 Hi-BIT/SAMPLING indicator
Lights when the AUDIO SCALER mode is on.
10 DSP indicators
MOVIE: Lights when a MOVIE mode is selected.
When a DSP MOVIE mode is selected DSP will
light with a box around it.
MUSIC: Lights when a MUSIC mode is selected.
When a DSP MUSIC mode is selected DSP will
light with a box around it.
11 Speaker indicators (see page 72)
Lights to indicate the current speaker system, A
and/or B.
12 Program Format indicators
For Dolby Digital or DTS sources: These
indicators change according to which channels
are active in the source. When all three
LS (left
surround), S (surround) and RS (right surround)
light at the same time it means a source with a
6.1 channel playback flag is being used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel or Surround back channel.
RS – Right surround channel.
LFE – Low Frequency Effects channel.
– Lights when LFE signal is input.
13 SB CH indicators (see page 53)
Light to indicate the status of the surround back
channels.
AUTO – Lights when the SB CH MODE or virtual
surround back mode is set to AUTO.
ON – Lights when the SB CH MODE or virtual
surround back mode is set to ON.
OFF – Lights when the SB CH MODE or virtual
surround back mode is set to OFF.
00_VSX-AX3.book Page 33 Monday, May 19, 2003 1:05 PM