Pioneer VSX-AX3-S - Manual (Page 90)

Expert System Settings
90
En
5 Use the  buttons to adjust the
frequency. When you have it at the
level you want press ENTER.
Set the frequencies within the –6 dB to +6 dB range in
steps of 0.5 dB. If OVER appears in the display you have
set the levels too high. Reduce them until OVER
disappears.
6 The cursor automatically goes to the
next frequency. Press ENTER and
repeat steps 4 and 5 to adjust all the
frequencies.
7 TRIM should be selected (if it isn’t use
the  buttons to select it) and press
ENTER.
8 Use the  buttons to adjust the
TRIM and press ENTER.
TRIM will balance the volume level of each frequency in
the overall volume of that speaker.
9 EXIT should be selected (if it isn’t use
the  buttons to select it) and press
ENTER.
10The cursor automatically goes to the
next channel. Press ENTER and repeat
steps 3 – 8 to adjust all the channels.
11EXIT should be selected (if it isn’t use
the  buttons to select it) and press
ENTER.
Leave the setup by using the  buttons to select EXIT
and pressing ENTER. You can now go to DATA CHECK or
leave the ACOUSTIC CAL EQ setting by using the

buttons to select EXIT and pressing ENTER.
5
7
9
00_VSX-AX3.book Page 90 Monday, May 19, 2003 1:05 PM