Pioneer VSX-AX3-S - Manual (Page 82)

Fine Tuning Your System
82
En
Function Rename
Use the FUNCTION RENAME capability to rename the display on the receiver and your OSD for different functions
(DVD, etc.). For example, you could rename VCR1/DVR as DVR-7000. For this particular setup using the controls on
the front panel is more convenient than using the remote control. Use the MULTI JOG dial instead of the

buttons and use the ENTER button on the front panel. You can also use the display on the front panel as opposed to
the OSD.
3-9 2
RETURN button
1 Turn on the receiver and your
TV. (If you want to use the
remote control for this setup,
press the RECEIVER button.)
2 Press the SET UP button.
This display appears on the receiver.
3 Looking at the display on your
receiver, use the MULTI JOG to
select FUNCTION RENAME.
Press the ENTER button.
4 Use the MULTI JOG to select
the name of the function (for
example, DVD/LD) you want to
change. Press ENTER.
Either the cursor underline bar or a character
(depending on which is selected) will blink.
The functions are divided into three different on-
screen displays so you may have to move
through them to find the function you want to
rename.
5 Use the MULTI JOG to cycle the cursor
through the letters, numbers and
symbols. Use the ENTER button to
enter one of the possibilities or move
forward a space.
The possible selections are shown below.
6 Repeat step 5 until you get the name
as you want it.
You can input up to ten characters.
7 Press ENTER repeatedly to exit the
name. The new function name is set.
8 Repeat steps 4-7 to change other
function names. Use the MULTI JOG
to select EXIT and press ENTER.
9 Use the MULTI JOG to select EXIT and
press ENTER.
This exits the SYSTEM SETUP mode and returns to
normal operation.
Memo:
Use the RETURN button to move the cursor back one
character when entering a name.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()*+,–./:;<=>?@[ \ ]ˆ_{|} [space]
00_VSX-AX3.book Page 82 Monday, May 19, 2003 1:05 PM