Pioneer CNDV-50MT - Manual (Page 120)

118
Appendix
NAVI/AV
Messages and how to react to them
The following messages may be displayed by your Navigation System.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Dialogue language (and subtitle lan-
guage) cannot be switched. The DVD playing does not feature
multiple language recordings. You cannot switch among multiple
languages if they aren’t recorded on
the disc.
You can only switch between items
indicated in the disc menu. Switch using the disc menu.
No subtitles are displayed. The DVD playing does not feature
subtitles. Subtitles are not displayed if they are
not recorded on the disc.
You can only switch between items
indicated in the disc menu. Switch using the disc menu.
Playback is not with the audio lan-
guage and subtitle language settings
selected in DVD SETUP. The DVD playing does not feature
dialogue or subtitles in the language
selected in DVD SETUP. Switching to a selected language is
not possible if the language selected
in DVD SETUP is not recorded on the
disc.
Switching the viewing angle is not
possible. The DVD playing does not feature
scenes shot from multiple angles. You cannot switch between multiple
angles if the DVD does not feature
scenes recorded from multiple
angles.
You are trying to switch to multiple
angle viewing of a scene that is not
recorded from multiple angles. Switch between multiple angles
when watching scenes recorded
from multiple angles.
The picture is extremely unclear/dis-
torted and dark during playback. The disc features a signal to prohibit
copying. (Some discs may have this.) Since this unit is compatible with the
copy guard analog copy protect sys-
tem, when playing a disc that has a
signal prohibiting copying, the pic-
ture may suffer from horizontal
stripes or other imperfections when
viewed on some displays. This does
not mean this unit is malfunctioning.
Message When What to do
Please insert the appropriate disc.
This is not the appropriate disc.
Please insert the appropriate disc.
•If you try to use a disc which is
incompatible with this system.
•If you insert a disc upside down.
•If the disc is dirty.
•If the disc is cracked or otherwise
damaged. •Insert a suitable disc.
•Insert the disc with the label
upward.
•Clean the disc.
•Insert a normal, round disc.
Irregular speed pulse signal is
detected. Please turn system power
off and check the installation. After
checking, please re-boot the system
and press “OK”. If the Navigation unit does not
receive the vehicle speed pulse. Consult your Pioneer dealer.
Speed pulse wire is not connected.
Please be sure to connect the system
to the speed pulse wire. Accuracy is
not fully ensured without speed
pulse. The speed signal input (pink lead
wire) of the power cable is not con-
nected. To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Vibration is detected. Please turn
system power off and check the
installation. After checking, please
re-boot the system and press “OK”. While the vehicle is stationary, the
Navigation System is installed in a
place where the navigation unit may
be affected by a large vibration. Re-install the navigation unit of the
Navigation System in a place where
the navigation unit will not be
affected by vibration.
Symptom Cause Action (See)