Pioneer CNDV-50MT - Manual (Page 97)

95
Chapter 8
Customising the Audio Source Setting
AV
(The navigation map screen can be displayed on
the right-hand side and the camera image can be
displayed on the left.) Please beware that in this
setting, camera image is not resized to fit, but
that a portion of what is seen by the camera is
not viewable.
• Pioneer recommends the use of a camera
which outputs mirror reversed images,
otherwise screen image may appear
reversed.
• Confirm the setting immediately whether the
display changes to a rear view camera image
when the gearstick is moved to REVERSE (R)
from another position.
• When the whole screen changes to a rear view
camera image during normal driving, switch to
another setting.
❒ Rear View can be displayed at all times (e.g.
when monitoring an attached trailer, etc.) as a
split screen where map information is par-
tially displayed. Please beware that in this set-
ting, camera image is not resized to fit, but
that a portion of what is seen by the camera is
not viewable.
❒ Initially, this function is set to OFF.
1
Touch “CAMERA” in the SETUP menu.
2
Touch “CAMERA” to turn reverse camera
setting on.
Touching “CAMERA” switches between
“ON” and “OFF”.
❒ Unless this setting is “ON”, you cannot
switch to Rear View mode.
3
Touch “POLARITY” to select an appropri-
ate setting for polarity.
Each time you touch “POLARITY” switches
between the following polarity:
• BATTERY — When the polarity of the con-
nected lead is positive while the gearstick is
REVERSE (R) position
• GND — When the polarity of the connected
lead is negative while the gearstick is
REVERSE (R) position
Selecting the video of rear dis-
play
When the navigation screen is displayed on front,
you can select either showing the navigation
screen on rear display or the video of the selected
source.
❒ The map screen navigation images output to
the rear display differ from standard NTSC for-
mat images. Therefore, their quality will be
inferior to the images that appear on the front
display.
1
Touch “REAR DISP” in the SETUP menu.
Each touch of the “REAR DISP” changes the
settings as follows:
• SOURCE — Display the screen of the
selected source on rear display
• NAVI — Display the navigation video on
rear display when the navigation screen is
displayed on front
❒ When selecting “SOURCE” in “REAR
DISP”, when the selected source is an
audio source, nothing is displayed on rear
display.
❒ When selecting “SOURCE” in “REAR
DISP”, nothing is displayed on rear dis-
play during a traffic announcement inter-
ruption or a news programme interruption.
❒ When selecting Rear View, nothing is dis-
played on the left-hand side of the rear dis-
play.
Setting the slide back function
You can adjust the LCD panel slide position to
prevent the display from hitting the gearstick of
an automatic vehicle when it is in P (park) posi-
tion.
❒ Please be careful, as the LCD panel will slide
immediately after the setting is turned “ON”.
1
Touch “FLAP SET BACK” in the SETUP
menu.
Touching “FLAP SET BACK” switches
between “ON” and “OFF”.
Other Functions