Pioneer CNDV-50MT - Manual (Page 53)

51
Chapter 4
Editing the Navigation Utilities
NAVI
Checking the Navigation Status
The navigation status, including the driving sta-
tus of a vehicle, positioning status by satellite,
learning status of the 3D sensor, and cable con-
nection status can be checked.
Checking sensor learning status
and driving status
1
Touch “Settings” in the Main menu, then
touch “Hardware Info”.
2
Touch “3D Calibration Status”.
The 3D Calibration Status screen appears.
(1) Distance
Driving distance is indicated.
(2) Speed Pulse
Total number of speed pulses is indicated.
(3) Learning Status
Current driving mode is indicated.
(4) Degree of learning
Sensor learning situations of distance
(Distance), right turn (Right Turn), left turn
(Left Turn), and 3D detection (3D Detection)
are indicated by the length of bars.
(5) Speed
Speed detected by this unit is indicated. (This
indication may be different from the actual
speed of your vehicle, so please do not use
this instead of the speedometer of your vehi-
cle.)
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of slope of the street is indicated.
To clear values...
If you want to delete the learned results stored in
“Distance”, “Speed Pulse” or “Learning Sta-
tus”, touch the relevant result, then touch
“Clear”.
❒ The Navigation System can automatically use
its sensor memory based on the outer dimen-
sions of the tyres.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation unit and the vehicle. Please also
check whether they are connected in the correct
positions.
1
Touch “Settings” in the Main menu, then
touch “Hardware Info”.
2
Touch “Connection Status”.
The Connection Status screen appears.
(1) Speed Pulse
The Speed Pulse value detected by this unit is
shown. “0” is shown while the vehicle is sta-
tionary.
(2) GPS Aerial
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from how
many satellites the signal is received.
If the signal is received correctly, “OK” is dis-
played. If reception is poor, “NOK” appears.
(3) Installation Position
The Installation position of the navigation unit
is shown.
(1)
(2)
(3)
(4)
(5) (7) (6)
(1)
(2)
(3)
(4)
(5)
(6)
(7)