Pioneer LX01 - Manual (Page 155)

The Initial Setup menu 15
155
En
AV2/L1 In Video • Sets the AV2 (INPUT 1/DECODER) SCART input to standard composite
video.
S-Video Sets the AV2 (INPUT 1/DECODER) SCART input to S-Video.
RGB Sets the AV2 (INPUT 1/DECODER) SCART input to RGB.
Decoder Use this setting if you connected a decoder to the AV2 (INPUT 1/DECODER)
SCART connector. For scrambled channels, make sure that the channel
Decoder setting is set to On. (See Manual CH Setting on page 154.)
NTSC on PAL TV On • NTSC discs will play correctly on PAL-only TVs.
Off Use if your TV is already NTSC-compatible.
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating instructions that came with
your TV. See also About NTSC on PAL TV on page 161 for related information.
Audio In
NICAM Select NICAM • Record the NICAM audio in a NICAM broadcast.
Regular Audio Record the non-NICAM audio in a NICAM broadcast. (You can still switch the
audio to record using the button (LCD page 3) before recording.)
Analog Tuner Level Normal • Standard setting.
Compression Use if the audio level from the built-in tuner is excessive, causing distortion.
External Audio Stereo • Select if the audio from the currently selected external input is standard
stereo.
Bilingual Select if each channel carries a separate soundtrack.
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or
bilingual. This has priority over the setting you make here.
Bilingual Recording A/L • Record the left (A) channel of a bilingual source when recording to HDD
with HDD Recording Format set to Video Mode On, to DVD-R/-RW (Video
mode) or DVD+R/+RW or in
LPCM mode, from an external source.
B/R As above, but for right (B) channel recording.
When recording bilingual audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording Format set to Video Mode Off (except
in LPCM mode), both audio channels are recorded and you can switch to the one you want on playback.
DV Input Stereo 1 • Select to use the ‘live’ audio track (recorded during the video shoot) from a
camcorder that supports two stereo audio tracks.
Stereo 2 Select to use the overdubbed audio track from a camcorder that supports
two stereo audio tracks.
Mix Select one of the three settings to use a mix of the two stereo audio tracks.
Audio Out
Dolby Digital Out Dolby Digital • Output a Dolby Digital signal when a Dolby Digital source is being played.
Dolby Digital 
PCM
Convert Dolby Digital sources to Linear PCM output. Use if your connected
equipment doesn’t have a Dolby Digital decoder.
DTS Out On • Output a DTS signal when a DTS source is being played.
Off Switch off the digital output when a DTS source is being played. Use when
your connected equipment doesn’t have a DTS decoder. In this case, use the
analog audio outputs.
Setting Options Explanation
02SDVRLX70D_EN.book 155 ページ ２００８年１０月９日 木曜日 午後４時３８分