Pioneer LX01 - Manual (Page 42)

Other connections 08
42
En
Listening to an external audio source
To listen to audio from a connected external component
on this unit, choose its input function on the remote
control. Some Pioneer products can be controlled via this
remote.
1 If the system isn’t already on, press SYSTEM ON
to switch on.
Also make sure that the external source (TV, satellite
receiver, etc.) is switched on.
2 Select an audio input source.
Input sources are cycled through as shown below:
The display changes to that of the selected input source.
3 If necessary, start playback of the external source.
Connecting external antennas
For an external AM antenna, use 5 to 6 meters of vinyl-
insulated wire and set up either indoors or outdoors.
Leave the loop antenna connected.
For an external FM antenna, use a PAL connector to hook
up an external FM antenna.
About control out connections
Many Pioneer components support CONTROL
connections, by which you can use the remote controls
of any connected components by aiming them at the
sensor of just one component.
When you use a remote control, the control signal is
passed along the chain to the appropriate component.
If you choose to use this feature, you must make sure that
you also have at least one set of HDMI or analog audio
jacks connected to another component for grounding
purposes.
• Using a cable with mono mini-plugs on either
side (sold separately), connect the CONTROL IN jack
on another Pioneer component to the CONTROL OUT
jack on the receiver subwoofer.
This will allow you to control the other component by
pointing its remote at the display unit supplied with this
receiver subwoofer.
Connecting using HDMI
If you have an HDMI or DVI (with HDCP) equipped
component, you can connect it to this receiver using a
commercially available HDMI cable. 1
The HDMI connection transfers uncompressed digital
video, as well as almost every kind of digital audio that the
connected component is compatible with, including
DVD-Video, DVD-Audio, SACD, Blu-ray Disc, Video CD/
Super VCD, CD and MP3, etc.
If you have a Pioneer Blu-ray disc player equipped with an
HDMI output terminal, connect it to the receiver
subwoofer’s
HDMI IN 2 terminal. The receiver
subwoofer’s input can be switched and the player
operated easily using the included remote control. (In the
same way, connect a Pioneer DVD player to the
HDMI IN
3 terminal.)
LINE
Digital 2
Front Audio In iPod
Analog Digital 1
AM LOOP
FM
UNBAL 75
Ω
ANTENNA
Side panel
Receiver subwoofer
external FM antenna
Outdoor antenna
external AM antenna
AM Loop antenna
PAL connector
(5 m to 6 m)
Indoor antenna
(vinyl-coated Wire)
Note
1 • An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High Bandwidth Digital Content Protection
(HDCP). If you choose to connect to a DVI connector, you will need a separate adaptor (DVI HDMI) to do so. A DVI connection, however, does not
support audio signals. Consult your local audio dealer for more information.
• This unit has been designed to be compliant with HDMI (High-Definition Multimedia Interface).
• This unit supports SACD, Dolby Digital Plus, Dolby TrueHD and DTS-HD Master Audio. To take advantage of these formats, however, make sure that
the component connected to this unit also supports the corresponding format.
From HDMI output
HDMI
T IN 3 IN 2 IN 1
Receiver subwoofer
HDMI OUT IN 3
SYSTEM
IN 2 IN 1
Rear panel
HDMI/DVI-equipped component
01SX-SW70SW_EN.book 42 ページ ２００８年１０月９日 木曜日 午後４時３２分