Pause live tv, Recording 06 – Pioneer LX01 User Manual

Page 96

Advertising

Recording

(LCD page 3) If you’re recording from the

A.TV tuner, select the audio channel to record.
See Changing A.TV audio channels on page 94 for more
on this.

• When recording in VR mode, if a broadcast is

bilingual, both audio channels are recorded, allowing
you to switch the audio channel on playback. The only
exception to this is when the picture quality is set to
LPCM, in which case you do need to select the audio
channel before recording.

(LCD page 3) If you’re recording from the

D.TV tuner, select the audio language to record.

• You may also be able to set which subtitle language

to record; use the

button (LCD page 3)

to select.

• Note that audio and subtitle languages cannot be

changed during the recording of a digital broadcast.

(LCD page 1) Start recording.

If you want to set a recording end time, press the

 REC

button repeatedly. The recording time increases in 30
minute increments, up to a maximum of six hours. The
time the recording will end is shown on-screen and in the
front panel display. When the recording ends, the
recorder automatically switches into standby if no other
operation is being performed.

• To cancel the set recording time, press

 REC.

• If you want to pause recording at any time

, press

 (Pause). Press again to restart the recording (If
recording to the HDD, DVD-RAM or in VR mode, a
new chapter is started after recording restarts).

Press to stop recording.

• If you set the recording time in the previous step, you

can still stop the recording anytime by pressing
STOP REC.

• Recording will stop automatically when there is no

more space on the HDD/DVD, or after 12 hours of
HDD recording (whichever is sooner).

Tip

• During recording you can turn on/off the SCART loop

through function. During recording, press the

INPUT

button

(LCD page 2) to switch to SCART THRU (loop

through on) or

SCART NORM (loop through off).

Loop through is automatically reset to off after
recording has finished. Note that you can’t switch
loop through on if recording from the

AV1 (RGB)-TV

connector.

Pause Live TV

The Pause Live TV feature lets you effectively pause a TV
programme you’re watching. When you’re ready to
resume watching, just press the

 (Play) button (LCD

page 1).

Setting up for Pause Live TV

You can use the Pause Live TV feature with an AV Link-
compatible TV connected using a SCART cable (see TV
tuner setup for Pause Live TV below), or using this
recorder’s internal tuner (see Using the recorder’s
internal tuner for Pause Live TV on page 97).

TV tuner setup for Pause Live TV

To use this feature with an external TV tuner, the recorder
must be connected to your TV using a SCART cable, and
the AV. Link setting (page 160) should be set to This
Recorder Only.

See also Pause Live TV on page 160 for