Pioneer LX01 - Manual (Page 40)

Other connections 08
40
En
Chapter 8
Other connections
Important
• When making or changing connections on the side
panel of this unit, be sure to switch power off and
disconnect the power cord from the wall socket.
After completing all connections, connect the power
cord to the wall socket.
• Press to set the remote control to receiver
control mode in order to operate the receiver
subwoofer (make sure that the LCD displays the
SYSTEM screen, as shown below).
Using this unit for TV audio
To listen to audio from a TV, connect the TV’s audio cable
to one of the inputs on this unit.
• Connect the audio output jacks on your TV to the
audio input jacks on the receiver subwoofer.
• You can connect by either a digital or analog audio
cable. Select only one method to make connections.
• To use the HDMI Control function when you are
connected to a supported Pioneer Flat Screen TV, you
must connect via HDMI.
• When digital connections are used, it may be
necessary to adjust the digital audio output settings
on the TV. For details, consult the operating
instructions for your TV.
Audio input settings from TVs (TV Input)
To listen to audio from a Flat Screen TV on this device, you
will need to connect an audio cable other than an HDMI
cable. From this menu, set the audio input to that which
you would like to connect. Press
TV on the remote
control to switch this unit to the input source selected
here. This setting is changed to the selected input and
the audio from the Flat Screen TV is output from this
device.
Select from inputs Digital 1, Digital 2 and Analog.
1 Press SETUP.
2 Select ‘System Setup’ then press ENTER.
3 Select ‘TV Input’, then press ENTER.
4 Adjust the setting then press ENTER to
confirm.
Connecting auxiliary components
You can connect both analog and digital external audio
sources to this system. Digital audio sources include
digital satellite receivers, CD recorders, etc.
We recommend using an HDMI cable to connect
sources that have HDMI terminals. For more information
see Connecting using HDMI on page 42.
SYSTEM
CONTROL
SYSTEM
SURR
ADV.
SURR
F.S.
SURR
AM LOOP
ANTENNA
R
L
ANALOG
AUDIO IN
OPTICAL
IN 1 IN 2
DIGITAL
From digital audio
output (optical)
or
From Audio output
TV
Side panel
Receiver subwoofer
SETUP
ENTER
ENTER
ENTER
01SX-SW70SW_EN.book 40 ページ ２００８年１０月９日 木曜日 午後４時３２分