Pioneer LX01 - Manual (Page 72)

Getting started 03
72
En
The system uses your postal code to identify which TV
listings data is correct for the area in which you live, so it
is important that you enter it correctly.
4 If you are using an external receiver (such as a
satellite receiver) with the supplied G-LINK cable,
complete this step, otherwise jump to step 5 below.
• See Connecting to a cable box or satellite receiver on
page 63 for more on using the supplied G-LINK cable.
• Select External Receiver 1, 2 or 3, then press
ENTER. (If you have just one external receiver, use
External Receiver 1. You can add further receivers in
2 and 3 if you need to.)
After pressing ENTER:
• Select your reception method ( Terrestrial, Cable or
Satellite).
• Select your provider (if applicable).
• Select the brand of your external receiver.
• Identify which input your external receiver is
connected to.
After completing these steps the recorder will try and
communicate with your external receiver and change the
channel via the G-LINK cable. If the channel was
successfully changed, select
Yes to confirm.
If the channel did not change, select No. The GUIDE
Plus+ system will try other codes assigned to your
external receiver. If none of the codes changes the
channel successfully, tune your external receiver to the
Host Channel for your country (refer to step
5 below) and
leave it on overnight. The recorder needs to be in standby;
it will wake up automatically and download new codes
from the Host Channel. The next day, try this setup
process again:
• Press GUIDE to display the GUIDE Plus+ screen.
• Press  to highlight the Menu bar, then use  to
reach the Setup area and select Setup.
• Continue setting up from the start of this step again.
If your external receiver still doesn’t respond to the G-
LINK controller, please call customer support and report
the brand and model of your external receiver.
See also GUIDE Plus+ FAQ and troubleshooting on
page 83.
5 Identify the Host Channel for your country.
The TV listings information available in the GUIDE Plus+
system is distributed throughout Europe by selected
broadcasters called Host Channels. It is important that
the host (analog) channel for your country is correctly
identified in order to receive listings information (EPG
download).
Follow A, B or C below depending on your setup:
A If you are not using an external receiver, this
recorder will automatically scan all channels for the
Host Channel:
• Leave the recorder in standby overnight (do not leave
it switched on).
B If you are using an external receiver, you need to
identify the Host Channel from the table below:
• Tune your external receiver to the appropriate Host
Channel and leave the receiver on and the recorder in
standby overnight.
C If you use both an external receiver and this
recorder as sources, follow the instructions above for
setting up without an external receiver. Only if this is
unsuccessful try the external receiver method.
About EPG download
• EPG data can only be received when the recorder is
in standby. (When not using the recorder, therefore,
please switch it into standby.) If you’re using an
external receiver, leave this on when EPG data is
downloading.
Country/
Region Host
Channels
Comments
Austria Eurosport
Belgium RTL-TVI
France Canal+ Analog only
Germany Eurosport
Italy MTV Analog only
Netherlands Eurosport
Spain Tele 5 Analog only
Switzerland Eurosport
UK ITV, Eurosport ITV is analog only. Use Eurosport
if you are a SKY subscriber and
you no longer have an analog
terrestrial antenna.
02SDVRLX70D_EN.book 72 ページ ２００８年１０月９日 木曜日 午後４時３８分