Bay Technical Associates DS4-RPC - Manual (Page 15)

DS-RPC OWNER’S MANUAL
QUICK START
__________________________________________________________________________________________
8
Accessing RPC Menu Select the RPC module. The following
status menu appears:
DS-RPC Series
(C) 1997 by BayTech
Rev. F0.04
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : Off
4) . . . OUTLET 4 : Off
RPC >
If the status menu fails to appear, ensure the
correct cables and adapters are being used
and that they are connected properly. Also,
verify the serial communication parameters
are correctly configured.
Controlling Receptacles To set or change the status of the
receptacles, enter one of the following
commands: ON n, OFF n, REBOOT n,
where “n” is the outlet number you want to
command. Entering an outlet number of
“0” sends the command to all outlets.
Reboot only works on outlets which are in
the “ON” condition.
DS-RPC MODULE CONFIGURATION
Accessing Configuration From the DS-RPC Main Menu, select
Menu C, “Configuration,” followed by <cr>. The
following selection menu appears:
Configuration
Module 1 ................................................1
Module 2 ................................................2
Module 3 ……………………………….3
Select Port .............................................S
Exit ........................................................X
Enter Request :