Fcc radio frequency interface statement, Fcc requirements for the ds71-md2 – Bay Technical Associates DS4-RPC User Manual

Page 79

Advertising
background image

DS-RPC OWNER’S MANUAL
FCC RADIO FREQUENCY INTERFACE STATEMENT
__________________________________________________________________________________________

72

FCC RADIO FREQUENCY INTERFACE
STATEMENT

This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with this manual, may cause
interference to radio communication.

This equipment has been type tested and found to comply within the limits
for a Class A digital device pursuant to Subpart J of Part 15 of FCC rules.
FCC rules provide reasonable protection against interference with radio
communications in a commercial environment. Not installing in
accordance with this manual or operating this unit in a residential
environment is likely to cause interference. In such cases, the user will be
responsible for the expense of correcting the interference.

FCC REQUIREMENTS FOR THE DS71-MD2

a. Federal Communications Commission (FCC) has established rules

permitting a direct connection to the telephone network. These
connections use standardized jacks. Do not use this equipment on
party lines or coin lines.

b. If this device is malfunctioning, it may also be causing harm to the

telephone network; disconnect this device until the source of the
problem is determined and repairs made. The Telephone Company
may temporarily disconnect service until the problem is corrected.

c. The Telephone Company may make changes in its technical

operations and procedures. If such changes affect the compatibility
or use of this device, the Telephone Company is required to give
adequate notice of the changes. In this case, you have the right to
file a complaint with the FCC.

d. If the Telephone Company requests information on connected

equipment to their lines, inform them of the following:

Advertising
This manual is related to the following products: