Hornady AP with Case Feeder - Manual (Page 14)

14
Step 8: Inserting the cam wire into the assembly.
See figure 8 for more details.
Figure 8: Assembly of cam wire.
• Raise the ram to the top of the stroke.
• Screw one #10-32 Hex Nut (#41) on to the Cam Wire (#43) approximately 1”
from the end.
• Place one of the #10 Flat Washers (#67) onto the Cam Wire (#43).
• From the bottom of the Sub-Plate (#44), slide the non threaded end of the
Cam Wire (#43) through the slot of the Sub-Plate (#44) and through the Case
Slide (#38).
• Insert the threaded end of the Cam Wire through the hole of the tab on the
Main Bracket (#42).
• Insert the other Flat Washer
(#67) and Hex Nut (#41) onto the bottom of the
Cam Wire (#43) and tighten finger tight.
• Lower the ram.