Hornady AP with Case Feeder - Manual (Page 7)

7
• The Ram can be blocked into place by inserting the handle of a medium sized
screw driver between the “Toggle” and the “Yoke” near the pawls. Be careful not
to put extreme pressure on the Index wheel as you may damage it.
• Use a 5/32” Allen wrench to remove the two screws that secure
the Sub-Plate
onto the ram.
• Remove the “Block” and lower the ram and remove the “Sub-Plate”.
• Install the new “Sub-Plate”, raise the ram and replace the “Block” before
installing the screws and tightening them very tight. (Be careful not to strip the
socket or damage the threads.)
• Once again, remove the “Block”, lower the ram and replace all parts in the reverse
order that you removed them.
The instructions thru Step 5 are for a Lock-N-Load Auto Progressive Frame without
the new machined bosses on the frame, serial # 07279 and later.