Hornady AP with Case Feeder - Manual (Page 25)

25
Figure 18: Case feed bowl door adjustment.
• Select the Case Feed Plate (item #54-57) for your application and place it on the
motor shaft. The clutch on the plate will slip onto the motor shaft fitting flush to
the bottom of the Case Feed Bowl (#1).
• Place the O-Ring onto the Feed Tube Large (#13) approximately 2” from one end.
The O-Ring when pushed down on top of the Feed Tube End (#15) will hold the
feed tube into the funnel on the case feed bowl.
• Set the Case Feed Bowl (#1) on top of the Square Tubing (#49) while inserting
the Feed Tube (#13 or #14) into the Case Feed Funnel Assembly (#8) and plug it
into a power outlet.
• If you are loading rifle cartridges you will need to adjust the Case Feed Door
(#37).
• Loosen the ¼” Button Head Cap Screw (#68) and slide the Case Feed Door
Adjustment (#37) so the opening is approximately ¾ the length of the case. This
is a preliminary setting. Place
a hand-full of cases into the Case Feed Bowl (#1).
• Turn the motor on and observe to see if the cases will fall base first. If they do
not, readjust the Case Feed Bowl Door Adjustment (#37) until they do with out
hanging up or getting caught.
• Re-tighten the ¼” Button Head Cap Screw (#68).
• To load pistol cases, completely open the Case Feed Door Adjustment.
See figure 17 for more details.