Hornady AP with Case Feeder - Manual (Page 22)

22
Step 15: Assembling the feed tube end and pivot.
See Figure 15 for more details.
Figure 16: Pivot Assembly.
• If the maximum case diameter is larger than .43 you will need to use the large
tube (#22). If it is smaller, you will need the small tube (#53). Place the correct
one into the pivot block (#29).
• Place the torsion spring (#23) into the slot in the pivot block (#29), leaving the
long leg on the top side. The spring will only fit one way.
• Set the pivot (#19) on top of the pivot block. Make sure you line up the under cut
on the cam with the torsion spring. The leg of the torsion spring will fit into the
slot on the cam.
• When this fits together the pivot should fit on top of the pivot block. The dowel
pin in the cam will fit into the curved slot on the cam block.
• Then insert the shoulder bolt (#20) into the pivot and into the pivot block and
tighten with an allen wrench.
• Actuate the pivot by hand to make sure it will rotate properly.
• For small rifle cases place the pivot adapter bushing (#51) into the hole of the
pivot adapter. See pg. 25 for more details.
• Place the pivot adapter (#18) on top of the pivot for rifle cases (See pg. 25 for
more details).