Hornady AP with Case Feeder - Manual (Page 20)

20
Step 14: Setting the timing of the cam wire.
Figure 13: Adjusting the V-block.
• Place a case of the proper size into the shell plate and manually push the Case
Slide (#38) and V-Block into the case. Loosen the Cap Screw (#59) and
continue to push the Case Slide into the case. Tighten the Cap Screw (#59)
with a 3/16” allen wrench.
See Figure 13 for more details.
Figure 14: Feeding a case.
• Raise the ram until the shell plate rotates and place a case (of the proper size)
in-front of the V-Block on the Sub-Plate. Lower the ram so the Case Slide
will advance the case into the shell plate.