Hornady AP with Case Feeder - Manual (Page 8)

8
Step 3: Assemble the square tubing brackets.
See Figure 3 for more details.
Figure 3: Square tubing bracket with set screws.
• Lay the two Brackets (#45) in front of you along with two 5/16-18 x 5/8 Cup Set
Screws (#35) and two 5/16-18 x 5/8 Cone Point Set Screws (#36).
• Place one Cone Point Set Screw (#36) into the side of the Square Tubing Bracket
(#45) until the point is just flush with the inside surface of the Bracket.
• Place one (#35) Cup Set Screw in the back of the Bracket until the cup point is
just flush with the inside of the Bracket.
• Repeat these steps for the second Bracket.