Hornady AP with Case Feeder - Manual (Page 18)

18
Step 12: Installing the V-Block onto the case slide.
Figure 12: Inserting the V-block.
• With the ram at the bottom of the stroke (idle position), set the V-Block (item
#60-#65) onto the Case Slide (#38).
• Place the #10-24 X 1/2 Cap Screw (#59) through the hole of the V-Block and
screw it into the Case Slide . Before you tighten the Cap Screw, push the V-Block
back into the Case Slide and snug the Cap Screw with your fingers.