Apple Workgroup Server 8150/110 - Manual (Page 47)

10 Press the card firmly until the connector is seated.
m Don’t force the card. If you meet a lot of resistance, pull it out and
try again.
m To see if the card is properly connected, wiggle it gently. If it resists and
stays in place, it’s connected.
If you have other cards to install, put them in now by repeating steps 5 through 9.
11 If you removed the expansion card clip (as described in step 4), replace it.
Put the bottom of the clip in place first. Make sure the edge of the expansion
card fits into one of the slots on the clip.
Installing an expansion card 31