JLG X14JH Operator Manual User Manual
Page 30
27
BOOM LIFT MODELS X14JH
JLG
X14JHR0220311
R
EF
.
D
ESCRIPTIONS
P
ICTOGRAMS NEAR THE
CONTROL
7
Load cell pilot light.
This red light indicates that the maximum admitted load
on the platform control car has been exceeded.
On the machine the light comes on when:
‑ you exceed 120 kg on the control car and the jib method
has been selected with selector 4.
‑ you exceed 200 kg on the control car and no jib method
has been selected with selector 4.
When the light comes on, it is accompanied by an inter‑
mittent alarm.
8
Machine closed pilot light
This red light indicates that the overhead part of the
machine frame has been completely lowered and aligned
with the base and that the withdrawing has completely
happened. When this light comes on, the stabiliser
controls and the crawler movements have been enabled.
Two golden arrows, situated near the hydraulic controls
on the crawler, visually signal the machine alignment.
9
Stabilised machine pilot light
This green light indicates that the stabiliser cylinders are
completely opened and therefore all the stabilisers are
resting on the ground.
Once the machine is stabilised the controls for moving
the overhead part of the frame and rotating the fifth
wheel are enabled.
The operator must make sure that the machine is
stabilised without the 1° maximum limit admitted by
the manufacturer.
10
Second speed button (optional)
If pressed and kept in position during the machine’s
translation it controls the switching of the second speed.