JLG X14JH Operator Manual - Manual (Page 67)

2.11.2.1 HOW AND WHERE TO HOOK THE PLATFORM
To lift the platform, hook it to each support pin of the stabiliser cap as indicated on the pho‑
tograph below.
Always hook all four feet as the machine could become unbalanced. Always use four separa‑
te cables, chains or slings; this way, the breakage or an improper anchoring of a connecting
device would not cause dangerous movements of the load.
2.11.2.2 WHAT TO USE FOR HOOKING THE PLATFORM
The lifting device must be in a good state of preservation and used according to the specifi‑
cations supplied by its manufacturer. As the platform weight is not divided equally on the
four stabilisers, the maximum requested load for each of the four cables, chains or slings
used must be:
no lower than 600 kg and their length not shorter that 2,5 m and identical between each
other.
The width of the slings must not be over 40 mm, the chains must not be over 25 mm, the
cable diameters must not be over 25 mm not to exercise a pressure on the stabiliser cap in an
anomalous direction.
Using cables, chains or slings with lengths lower than 2.5m could cause permanent damages
to the machine stabilisers.
BOOM LIFT MODELS X14JH
JLG
64 X14JHR0220311
PERICOLO
IMPORTANTE
DANGER
IMPORTANT