JLG X14JH Operator Manual User Manual
Page 66
63
During the translating and the changing of slant phases, take care not to damage the safety
devices situated below the basket and near the first withdraw end. If the change of slant was
to be too excessive, change the inclination of the ramps or use longer ramps.
2.11.2 LIFTING THE MACHINE
To lift the machine you need lifting equipment with a proper load according to the distance
and the height you want to lift the platform.
•
For the lifting operations necessary for maintenance or loading on means of transport
only use machinery (e.g. cranes, overhead travelling cranes etc.) and loading devices
(e.g. cables, chains, hooks) of proper load and in perfect state of preservation; to check
the machine weight consult the paragraph relative to the platform technical data.
In the photograph below, you can see how and where the platform must be hooked.
•
When you lift the machine, it must be in transport configuration (arms completely clo‑
sed and lowered, stabilisers completely raised and crawler widened). If not the machine
would be unbalanced and the lifting dangerous.
•
Never lift the machine with an operator on board.
•
During the lifting phases make sure that no one is in the operating area and always
avoid transiting the suspended machine over people.
Never lift the machine slinging it differently than the one shown; if for example it was lifted
with one arm hooked exploiting the ground anchoring devices (not planned to bear the
platform weight) or simply passing a sling around any arm elements, this would load force‑
fully the fifth wheel and other elements of the machine for which they have not been plan‑
ned. It is highly probable that this will cause structural damages to the machine.
BOOM LIFT MODELS X14JH
JLG
X14JHR0220311
IMPORTANTE
ATTENZIONE
IMPORTANTE
IMPORTANT
IMPORTANT
WARNING