JLG X14JH Operator Manual User Manual
Page 52
49
‑
If the stabiliser ground pressure should exceed the ground admitted pressure, increase
the resting surface interposing slabs or a foundation of stable material (e.g. wood)
between the ground and the stabilizer cap.
FOOTSWITCH
To allow the aerial, undercarriage and stabilization movement of the machine the foot‑
switch device inside the basket must be pushed. If you try to move the machine without
the footswitch pushed the movement will be prohibited.
2.9.1 PRELIMINARY CHECKS BEFORE STARTING OPERATING
Do the following every day before starting work:
‑
Check that there are no oil leaks from the machine hydraulic system. In case of leaks do
the necessary repairs and top up the level of hydraulic oil (see paragraph about mainte‑
nance operations). Clean the area with a solvent or a detergent and water under pressu‑
re.
‑
Check that there are no starts of corrosion and that there are no cracks near welding.
‑
Check the integrity and the proper working of the rubber tracks belts (see paragraph
about maintenance operations).
‑
Check that there are no broken, damaged or missing components. Check the proper
tightening of the pin locking screws and nuts or safety ring nuts. Replace, tighten and
adjust according to the platform manufacturer’s instructions before operating the machi‑
ne.
‑
Eliminate debris that could cause fires or breakage taking care to the machine control
area and the area around the diesel/petrol engine.
‑
Clean the handrail, footboards and control levers from any oil residues or debris that
could compromise the execution of the manoeuvres in complete safety putting the ope‑
rator at risk. Check the integrity of the pilot lights and the electric control on the electric
panel situated on the control car.
‑
Check the state of the stickers placed on the machine in a well visible way.
‑
Check that there is enough gasoil/petrol in the fuel tank to avoid any useless stops with
relative emergency descents.
‑
Check the proper working condition of the safety devices.
BOOM LIFT MODELS X14JH
JLG
X14JHR0220311