JLG X14JH Operator Manual User Manual
Page 49
2.8 PROCEDURES FOR A PROPER USE
You will find below the using procedures of JLG platforms. Any use different from what is
specified here, unless previously authorised the Constructor, is absolutely forbidden.
2.8.1 OPERATOR’S RECAPITULATORY TABLE OF SAFETY REGULATIONS
You will find below the recapitulatory table with the general safety regulations that the ope‑
rator must follow carefully before starting operating the platform.
We remind you that there is a sticker showing this table near the controls on the control car,
which can easily be seen from the control place.
•
The operating of the platform is only meant for assigned and previously trained staff.
•
All the controlling manoeuvres of translation, stabilisation of the machine and move‑
ment of the extensible structures must be done from the control place on the control car.
•
Follow carefully all the instructing and operating instructions indicated in the
INSTRUCTING AND OPERATING MANUAL annexed to the machine.
•
Never exceed the maximum admitted load indicated on the INSTRUCTING AND OPE‑
RATING MANUAL and on the machine with well visible indications applied on the
control car.
•
The operator must wear a helmet and fasten safety belts on proper anchors on the con‑
trol car.
Remember that the safety belts must be checked.
The use of the safety belts is compulsory in connection with the local regulatins of every
single State. In those States where the law does not require the use of holding systems,
the choice is of the employer or/and user.
•
Before starting work, the operator must make sure that the safety devices are in perfect
working condition, that the main mechanical parts and the fuel and oil level are in
working order.
•
Never operate on sinking, uneven and slippery grounds or with slopes exceeding the
maximum admitted inclination as this could make the platform unstable.
•
Level perfectly the machine frame observing the maximum admitted inclination as indi‑
cated in the INSTRUCTING AND OPERATING MANUAL and visible on the water
level.
•
Before doing any movement, check that there are no obstacles and no people in the
trajectory on the working area.
•
It is forbidden to work within a 5 m distance from the distribution lines and electric
equipment.
•
It is forbidden to operate in bad weather conditions unless it is absolutely necessary.
•
It is forbidden to anchor cables, ropes or other on the platform.
•
It is forbidden to fix ladders, tools or other on the control car to increase the working hei‑
ght.
BOOM LIFT MODELS X14JH
JLG
46
X14JHR0220311